Heart Silicone Mold - Trinket Bowl

This sweet little heart trinket mold will become your new favorite go-to, especially when you have just a little bit of left over resin. Trust us -- you cannot have too many of these little bowls!

If using deep pour resin, add glitter and create a cool border effect on the edge as the glitter drops to the bottom (top) of the mold. If using regular viscosity resin, create all kinds of cool looks and effects with glitters, powders and inks! 

This mold measure 3.25" X 2.8" and just under 1" deep.

And of course, these molds are 

• Flexible, soft and reusable
• Made of non-toxic silicone; BPA free
• Heat resistant: -40 to +446 degrees Fahrenheit, (-40 to +230 degrees Celsius)
• Non-stick for easy release

Tips (always follow instructions for the resin you are using - these are meant as general guidelines):

• Always pour your resin into the hardener (pour hardener into the mixing container first, then resin). 
  
• Stir resin with a plastic or silicone stirring stick to reduce air bubbles. Wood is not recommended as it can create air bubbles.
• Let resin sit a few minutes after stirring to reduce air bubbles.
• Don’t use a torch or heat gun as it could damage the molds and make it difficult to de-mould, causing them to tear - this is especially true near the edges.
• Wash mold as needed in warm soapy water.